來源：http://www.pencildreams.com/ 發布時間：2021-04-07 瀏覽次數：
In the automatic welding process of pressure vessel automatic welding equipment, the wrong operation or unexpected situation may lead to some problems in the welding process, so it may lead to serious consequences if it is not solved in time. Below by the small ribbon you in the process of automatic welding simple fault processing
1. In the welding process, it is found that the arc is generated between the nozzle and the workpiece, which leads to the double arc phenomenon. After this phenomenon, the welding parameters current and ion gas should be adjusted in time, too much current and too little ion gas will cause double arc.
2. Smoke was found at the nozzle of plasma welding gun during welding. To stop welding, check whether the water tank is open and whether the water meter shows the amount of water. If there is no water passing through the welding gun, the welding gun is burnt out and needs to be repaired by professionals.
3. In the process of tungsten alignment, high frequency is not used. In this case, the nozzle should be cleaned in time, the metal should be polished with metallographic sandpaper, and the tungsten needle should be ground again.
4. There are pores in the weld. The reasons may be that the base metal has oil, rust and other dirt; the gas protection effect is poor; the gas path is not clean; the gun head leaks. The workpiece should be cleaned, the arc voltage should be reduced, the welding speed should be reduced, the new gas should be used, the pipeline should be renewed, and the O-ring should be replaced.